Brief Introduction

LR-XN11C

ModelLR-XN11CTypeNPN Output/PNP Output (Selectable output)Cable/ConnectorM8 connector*1Main Unit/Expansion UnitMain Unit (expansion not possible)No. of Control Outputs2*2No. of External Inputs1*2Response Time500 µs*3/1 ms/3 ms/10 ms/200 ms SelectableIO-LinkSpecification v1.1/COM2 (38.4 kbps)FunctionsTimer FunctionTimer OFF/Off-delay/On-delay/One-shot/On-Off delay/On-delay One-shotI/OControl OutputOpen collector, 30 VDC or lower, N.O./N.C.100 mA or lower for 1 output; 100 mA or lower in total for 2 outputsResidual voltage NPN: 1.4 V or lower (output current: 10 mA or lower)/2 V or lower (output current: 10 to 100 mA), PNP: 1.6 V or lower (output current: 10 mA or lower)/2.2 V or lower (output current: 10 to 100 mA)External InputExternal Set/Laser OFF/Zero Shift/Hold Reset/Gyro Alert RST selectableShort circuit current - NPN: 1 mA or lower, PNP: 2 mA or lowerInput time: 3 ms or more ON, 20 ms or more OFF (25 ms or more ON, 25 ms or more OFF only when External Set is selected)Unit Expansion—Protection CircuitProtection against reverse power connection, protection against output overcurrent, protection against output surge, protection against reverse output connectionNumber of Interference Prevention Devices—Power supplyPower voltage16 to 30 VDC*4 (including 10% ripple (P-P) or less), class 2Power consumptionDuring normal operation: 1150 mW (47 mA or lower at 24 V, 64 mA or lower at 16 V), ECO ON/ALL: 985 mW (40 mA or lower at 24 V, 53 mA or lower at 16 V) (excluding Load Current)Environmental resistanceAmbient temperature−20 to +55°C -4°F to 131°F (no freezing)*5Relative humidity35 to 85% RH (no condensation)Vibration resistance10 to 500 Hz; Power Spectral Density: 0.816 G2/Hz; X, Y, and Z directionsShock resistance500 m/s2 (50G); 3 times each for X, Y, and Z axesCase MaterialMain Unit and Cover: PolycarbonateAccessoriesInstruction manualWeightApprox. 22 g*1 Ensure the cable length is 30 m 98.4' or less for the M8 connector type. Ensure the cable length is 20 m 65.6' or less when connecting via IO-Link.*2 Output 2 and the external input are selectable.*3 If 500 µs is selected, the following limitations apply.· Only 2-point calibration can be performed.· The detection range masking is set during calibration. (Manual setting of the masking range is not supported.)· Output 2 is limited to an alarm output for errors and gyro issues, and standard/area cannot be used.· The interference prevention function is not supported*4 When expanding the system with 4 or more expansion units, use a power voltage of 20 V or higher.*5 Expansion by 1 or 2 units: −20 to +55°C -4°F to 131°F; Expansion by 3 to 10 units: -20 to +50°C -4°F to 122°F, Expansion by 11 to 16 units: -20 to +45°C -4°F to 113°F